- Connecting via USB to probe/ programmer device 0
 - Probe/ Programmer firmware: J-Link V9 compiled May  7 2021 16:26:12
 - Device "STM32F103C8" selected.
 - Target interface speed: 4000 kHz (Fixed)
 - VTarget = 3.301V
 - InitTarget() start
 - InitTarget() end
 - Found SW-DP with ID 0x1BA01477
 - DPIDR: 0x1BA01477
 - Scanning AP map to find all available APs
 - AP[1]: Stopped AP scan as end of AP map has been reached
 - AP[0]: AHB-AP (IDR: 0x14770011)
 - Iterating through AP map to find AHB-AP to use
 - AP[0]: Core found
 - AP[0]: AHB-AP ROM base: 0xE00FF000
 - CPUID register: 0x411FC231. Implementer code: 0x41 (ARM)
 - Found Cortex-M3 r1p1, Little endian.
 - FPUnit: 6 code (BP) slots and 2 literal slots
 - CoreSight components:
 - ROMTbl[0] @ E00FF000
 - ROMTbl[0][0]: E000E000, CID: B105E00D, PID: 001BB000 SCS
 - ROMTbl[0][1]: E0001000, CID: B105E00D, PID: 001BB002 DWT
 - ROMTbl[0][2]: E0002000, CID: B105E00D, PID: 000BB003 FPB
 - ROMTbl[0][3]: E0000000, CID: B105E00D, PID: 001BB001 ITM
 - ROMTbl[0][4]: E0040000, CID: B105900D, PID: 001BB923 TPIU-Lite
 - Executing init sequence ...
  - Initialized successfully
 - Target interface speed: 4000 kHz (Fixed)
 - Found 1 JTAG device. Core ID: 0x1BA01477 (None)
 - Connected successfully
Reading target memory (0x08000000 - 0x0800FFFF) ...
 - Start of preparing flash programming
 - End of preparing flash programming
 - Blank checking 0x08000000 - 0x0800FFFF
 - Start of restoring
 - End of restoring
 - Target memory read successfully. (65536 bytes, 1 range) - Completed after 0.474 sec