BIST0-OK
[123456789A]13579]12468A]13579]BIST1-OK
[123456789A]36A]369D369CU[AT][MB][start ub][177]

U-Boot 2011.06-svn17534 (Sep 25 2015 - 00:11:18)

DRAM:  256 MiB

Hello U-Boot
Stack Pointer at: 87e88f40
mem initial, start 0x86dd0180, len 0x420000
uboot held at [8f000000~90000000]
Now running in RAM - U-Boot at: 871f0180
NAND:  [NC_ProbeDDRNAND]        SDR NAND is detected
CIS is found @Blk0
FCIE is set to 54MHz
256 MiB
*** Warning - set default for mtdparts, using default environment

Creating 1 MTD partitions on "nand0":
0x000000640000-0x000000840000 : "mtd=2"
Bad block table found at page 131008, version 0x01
Bad block table found at page 130944, version 0x01
nand_read_bbt: Bad block at 0x00000f6c0000
UBI: attaching mtd1 to ubi0
UBI: physical eraseblock size:   131072 bytes (128 KiB)
UBI: logical eraseblock size:    126976 bytes
UBI: smallest flash I/O unit:    2048
UBI: VID header offset:          2048 (aligned 2048)
UBI: data offset:                4096
UBI: attached mtd1 to ubi0
UBI: MTD device name:            "mtd=2"
UBI: MTD device size:            2 MiB
UBI: number of good PEBs:        16
UBI: number of bad PEBs:         0
UBI: max. allowed volumes:       128
UBI: wear-leveling threshold:    250
UBI: number of internal volumes: 1
UBI: number of user volumes:     1
UBI: available PEBs:             1
UBI: total number of reserved PEBs: 15
UBI: number of PEBs reserved for bad PEB handling: 2
UBI: max/mean erase counter: 1040/1033
Volume  not found!

NAND read: device 0 offset 0x1c0000, size 0xa8
 168 bytes read: OK
Volume "MPOOL" found at volume id 0
In:    serial
Out:   serial
Err:   serial
Net:   No ethernet found.
MAC:  0x0: 0x25: 0x92: 0x94:0x32: 0xdf
<NULL>
No recovery information, needless to recovery

Changelist:     00112233
============= set bootargs ===============
Hit any key to stop autoboot:  0
AC on
Check USB port[0]:
Host type:2
scanning bus for devices...
[USB] interface[0] conf:1 value 9:
Wait for hub reset....
checking hub ports...

[USB] interface[0] conf:1 value ff:
2 USB Device(s) found
       scanning bus for storage devices... 0 Storage Device(s) found
Check USB port[1]:
No USB is connecting
usb init failed
Error, couldn't init Lowlevel part

 UART BUS OFF!!