Hardware pinouts and cables schemes

ATA (44) internal pinout

connector wiring scheme

bookmark this page

This connector is mostly used for 2.5 IDE HDD of notebooks and so on. See ATA pinout for pins 1-40.

44 pin IDC (0.75") male connector layout
44 pin IDC (0.75") male connector
at the controller & peripherals


Pin Name Dir Description
41+5VL-->+5 VDC (Logic)
42+5VM-->+5 VDC (Motor)
43GND---Ground
44/TYPE-->Type (0=ATA)

Note: Direction is Controller relative Devices (harddisks).

44 pin IDC (0.75") female connector diagram
44 pin IDC (0.75") female connector
at the cable
 
 
Related Links:
Pinouts.ru > Hard drives connectors pinouts listing >  Pinout of ATA (44) internal and layout of 44 pin IDC (0.75") male connector and 44 pin IDC (0.75") female connector
Document status: correct
Source(s) of this and additional information: Hardware Book, Nick Schirmer 7 reports
Last updated at Sat Jun 25 2005. Submit additions or corrections for this document. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [Add new pinout]
This page contain parts under Copyright © 2000-2007 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.
34016 hits since March 4, 2005