8.2 SERVICE POSITION

TOP PREVIOUS NEXT

This Service Position is used for checking and replacing parts. Use the following Extension cables for servicing.

Table S1 Extension Cable List
No.
Parts No.
Connection
Form
1
 		VFK1364
 		FP9003 (MAIN) - LENS UNIT (AF)
 		14PIN 0.5 FFC
2
 		VFK1480
 		FP9004 (MAIN) - LENS UNIT
 		6PIN 0.5 FFC
3
 		VFK1284
 		FP9008 (MAIN) - LCD UNIT
 		24PIN 0.5 FFC
4
 		VFK1364
 		FP9006 (MAIN) - REAR OPERATION
 		14PIN 0.5 FFC
5
 		VFK1443
 		FP9007 (MAIN) - TOP OPERATION
 		18PIN 0.5 FFC
6
 		VFK1441
 		FP9005 (MAIN) - MIC UNIT
 		8PIN 0.5 FFC
7
 		VFK1443
 		FP9002 (MAIN) - CCD
 		18PIN 0.5 FFC
8
 		VFK1780
 		FP9009 (MAIN) - STROBE
 		15PIN 0.3 FFC
T8002 (MAIN) - STROBE
 		1PIN CLIP
9
 		VFK1783
 		P9009 (MAIN) - STROBE
 		2PIN 1.5 CABLE

CAUTION-1. (When servicing MAIN C.B.A. / STROBE UNIT)

  1. Be sure to discharge the capacitor on MAIN C.B.A. after removing the Rear case unit.

    Refer to “HOW TO DISCHARGE THE CAPACITOR ON MAIN C.B.A.”.

    The capacitor voltage is not lowered soon even if the AC Cord is unplugged or the battery is removed.

  2. Be careful of the high voltage circuit on MAIN C.B.A.

  3. DO NOT allow other parts to touch the high voltage circuit on MAIN C.B.A.

CAUTION / IMPORTANT. (WHEN HANDLING THE MAIN C.B.A.)

  1. DO NOT PRESS AND BENT THE JUNCTION AREA OF MAIN C.B.A.

    Since the Terminal board, Main board and Digital board of the Main C.B.A. are directly connected with Flexible Card, these junction areas are quite delicate.

Therefore, DO NOT hardly press and bent the junction areas of Main C.B.A.


TOP PREVIOUS NEXT