8.3 HOW TO DISCHARGE THE CAPACITOR ON MAIN C.B.A.

TOP PREVIOUS NEXT

CAUTION:

  1. Be sure to discharge the capacitor on MAIN C.B.A. after removing the Rear case unit.

  2. Be careful of the high voltage circuit on MAIN C.B.A. when servicing.

[Discharging Procedure]

  1. Refer to the disassemble procedure and Remove the necessary parts/unit.

  2. Peel off the Insulation Barrier.

  3. Put the insulation tube onto the lead part of Resistor (ERG5SJ102:1kΩ /5W).

    (an equivalent type of resistor may be used.)

  4. Put the resistor between both terminals of capacitor on MAIN C.B.A. for approx. 5 seconds.

  5. After discharging confirm that the capacitor voltage is lower than 10V using a voltmeter.

Fig. F1


TOP PREVIOUS NEXT